cos美女 cos美女 ,中文字幕 乱码视频 中文字幕 乱码视频 ,打飞机动态图 打飞机动态图

发布日期:2021年10月16日
cos美女 cos美女 ,中文字幕 乱码视频 中文字幕 乱码视频 ,打飞机动态图 打飞机动态图
FIT TOLERANCES FOR PARALLEL / TAPER KEY - KEYSEAT ASSEMBLIES

ANSI B17.1 standard identifies two classes of stock for parallel keys. One is a close, plus toleranced key stock and the other is a broad, negative toleranced bar stock. Each is combined with appropriate keyseat tolerances to make assemblies. Based on the use of two types of stock, two classes of fit are given. Class 1 is a clearance or metal-to-metal side fit obtained by using bar stock keys and keyseat tolerances. This is a relatively free fit and applies only to parallel keys. Class 2 is a side fit, with possible interference or clearance, obtained by using key stock and keyseat tolerances as given in this page. This is a relatively tight fit.

Fit Tolerances for Parallel & Taper Keys:

cos美女 cos美女 ,中文字幕 乱码视频 中文字幕 乱码视频 ,打飞机动态图 打飞机动态图 cos美女 cos美女 ,中文字幕 乱码视频 中文字幕 乱码视频 ,打飞机动态图 打飞机动态图
INPUT PARAMETERS
Key Type
cos美女 cos美女 ,中文字幕 乱码视频 中文字幕 乱码视频 ,打飞机动态图 打飞机动态图
Fit Type
Key Cross Section
Nominal Key Size Width [over - to (incl.)]


RESULTS
Parameter Value
Key Type --- ---
Fit Type ---
Key Cross Section --- cos美女 cos美女 ,中文字幕 乱码视频 中文字幕 乱码视频 ,打飞机动态图 打飞机动态图
Key Width [over - to (incl.)] --- inch
SIDE FIT
Key Width Upper Deviation --- inch
Key Width Lower Deviation ---
Keyseat Width Upper Deviation ---
Keyseat Width Lower Deviation ---
Maximum Clearance ---
Minimum Clearance ---
TOP AND BOTTOM FIT
Key Depth Upper Deviation --- inch
Key Depth Lower Deviation ---
Shaft Keyseat Depth Upper Deviation ---
Shaft Keyseat Depth Lower Deviation ---
Hub Keyseat Depth Upper Deviation ---
Hub Keyseat Depth Lower Deviation ---
Maximum Clearance ---
Minimum Clearance ---

Definitions:

Keyseat: An axially located rectangular groove in a shaft or hub. Hub keyseat has been sometimes referred to as a keyway

Sunk Key: A standard form of key with rectangular or square cross-section in which the key fits into the keyseats on the shaft and the hub.

Reference:

  • Oberg, E. , Jones ,F.D. , Horton H.L. , Ryffel H.H., (2016) . Machinery's Handbook . 30th edition.  Industrial Press Inc.
  • Oberg, E. , Jones ,F.D. , Horton H.L. , Ryffel H.H., (2012) . Machinery's Handbook . 29th edition.  Industrial Press Inc.
  • ANSI B17.1-1967, Keys and Keyseats